Place Order
Electrosense manufactures both Fresh and Waste Water Holding Tank Monitoring Systems. Electrosense products are customized for your specific tank’s need; therefore once your order has been received to insure accuracy someone may need to contact you.
Please be sure to read the Ordering Key Points below and the order form example.
Please be sure to read the Ordering Key Points below and the order form example.
| electrosense_order_form.pdf |
After the form has been completed, you can scan it and email it, fax it, or just take a picture of it and email it. You can also send the picture as a message to Chris's cellphone at 410-627-8952:
E-mail - chris.electrosense@gmail.com
Phone - 443-370-8383
Fax - 443-816-0701
Cell - 410-627-8952
Mail - Electrosense, Inc.
P.O. Box 526
Sparks, MD 21152
Payments – We accept Checks, Paypal, Visa, Amex and Master card payments.
Do not send your Card Number by e-mail; we will contact you by phone.
Ordering Key Points
|
|
Please note that our systems require no calibration or alignments; the monitors are customized for your tank therefore certain information is needed to ensure the most accurate readings:
- Type of System - Waste or Fresh Water
- Depth of tank at the sensor’s installation location
- Shape of tank – This information is important for the most accurate reading if your tank is NOT square or rectangular. If your tank has an odd shape, then we recommend including a sketch with dimensions or the tank’s manufacturer and part number (if available).
- Power Source – Connect to your boat's 12VDC system or small 12 Volt battery that attaches to back of display
- Signal Cable length – standard signal cable is 25’ and a 50’ cable is available for $15 extra.
- Display Color - 2 options (white or black)
- Flange - If you will be drilling a new hole into your tank, the Flange screws down over the hole and accepts the Sender
- Your Name, Shipping Address and contact information (email and phone)